Tandberg Data Autoloader Tandberg LTO2 - Manual (Page 83)

- 67 -
Messages
Messages such as the following are displayed as required.
Messages Related to the Drive Interface
Table-D6 Table of Messages Related to the Drive Interface
Message Description
Drive status
Calibrate The drive is being calibrated.
Cleaning The drive is being cleaned.
Erasing The drive is erasing.
Loading The drive is loading.
Locating The drive is locating.
Reading The drive is reading.
Rewinding The drive is rewinding.
REQ clean The drive is requesting a cleaning.
Unloading The drive is unloading.
Wait load Waiting for loading completion following execution of the Load command.
Wait unload
Waiting for unloading completion following execution of the Unload command.
Writing The drive is writing.
DRV full There is a cartridge in the drive.
DRV empty There isn't a cartridge in the drive.
Autoloader and Drive
COMM.ERROR The Autoloader detected a communication error with the drive.
Drive error and caution
DRV Err 1 There has been detection of the drive exceeding the recommended operation temperature.
DRV Err 2
There has been detection of the drive input voltage reaching the limit of or exceeding the
permissible range.
DRV Err 3 A drive firmware error has occurred.
DRV Err 4 A fault has occurred in the drive firmware or hardware.
DRV Err 5 A fault has occurred in the drive hardware.
DRV Err 6 A drive hardware or a media error has occurred.
DRV Err 7 A fault of the media has occurred.
DRV Err 8 An error has occurred in the drive hardware or SCSI bus.
DRV Err 9 An error has occurred in the drive hardware or RS-422 connection.
DRV Err A An error has occurred in the drive hardware.