Tandberg Data Autoloader Tandberg LTO2 - Manual (Page 6)

- iv -
Cautions for power source or power cable
WARNING
Do not handle the power plug with wet hands.
Do not connect/disconnect the plug with wet hands. Otherwise, an
electric shock may occur.
CAUTION
Do not insert the plug
into the outlet other than the one specified.
Use the wall outlet of specified voltage and power source. Use of
power sources other than the one specified may cause a fire or
electrical leakage.
Do not apply starburst wiring.
This device may overheat when current exceeds the rated value,
which may cause a fire.
Do not insert the plug halfway.
Insert the plug to the end. Inserting halfway generates heat from the
loose connection and may cause a fire. The plug also generates heat
when dust or droplets adhere to the inserting part, which may cause a
fire.
Do not use the power cable other than the one specified.
Do not use the power cable other than the one attached to the device
May cause a fire when current exceeds the rated value.
In addition, to prevent from an electric shock or a fire caused by
damage of the power cable, do not perform the following actions.
Pulling the power cable
Pinching the power cable
Bending the power cable
Pouring chemicals on the power cable
Twisting the power cable
Placing items on the power cable
Bundling the power cable
Modifying, processing or repairing the power cable
Fixing the power cable with staples, etc.
Do not use a damaged power cable (replace damaged power cable
with one with the same specification. For replacement, contact the
dealer from whom you purchased this device or a maintenance service company).