2 changing the scsi id – Tandberg Data Autoloader Tandberg LTO2 User Manual
Page 43
![background image](/manuals/215921/43/background.png)
- 27 -
3.6.2 Changing the SCSI ID
Operation Example 1
The operation procedure and LCD indications are described below when changing the SCSI ID
of the Autoloader from 0 to 1.
Operation 1
Switch ON the power and wait for the completion of the power-on test.
Display:
"READY" and "DRV empty" are alternately displayed.
Operation 2
Press the ENTER key.
Display:
STATUS
Operation 3
Press the arrow key and select the "SCSI ID" command.
Display:
SCSI ID
Operation 4
Press the ENTER key and define the command.
Display:
View ID?
Operation 5
Press the arrow key and select the "Set ID" command.
Display:
Set ID?
Operation 6
Press the ENTER key and define the command.
Display:
Lib.ID?
Operation 7
Press the ENTER key and define the command.
Display:
Lib. ID 0?
Operation 8
Press the arrow key and select the "Lib. ID1" command.
Display:
Lib. ID 1?
Operation 9
Press the "ENTER" key and define the command.
Display:
Complete
Operation 10
Set the power switch of this device to OFF.
Operation 11
Switch the power of this device ON again.