Tandberg Data Autoloader Tandberg LTO2 - Manual (Page 31)

- 15 -
3.2 Loading the Magazine
Follow the procedure described below to load the magazine into the Autoloader.
1. Check that the power of the Autoloader is ON.
Tip
The Autoloader has a double locking mechanism comprising a key operated
door lock and an electronic lock. When the power is in the OFF condition, the
electronic lock is activated by a solenoid and the door cannot be opened. When
it is necessary to open the door while the power is in the OFF condition, use
the emergency release key that has been supplied. See “3.8 Using the
Emergency Release Key” for information describing the use of the emergency
release key.
2. Use the door lock key supplied with the main unit to release the door lock, then open the front
door.
Tip
The Autoloader is designed so that the electronic lock operation will again be
activated if the front door is not opened within 10 seconds following the
release of the door lock with the door lock key. Should the door become locked
again, follow this same procedure to release the door lock and then open the
front door within 10 seconds.
3. Set the magazine as indicated in the figure and press the PUSH mark portion back until it
locks with a click sound.
4. Close the front door and lock it using the door lock key supplied with the main unit.
Figure 3-3 Loading the Magazine