Tandberg Data Autoloader Tandberg LTO2 - Manual (Page 55)

- 39 -
5.1.2 Cleaning the Roller inside of the transporter
When the Alarm LED is blinking and "REQ CLNROL" message is displayed on the LCD, the
Autoloader is requiring to clean the Roller inside of the transporter, hereafter called
CLNROL-function.
As been described above, this Autoloader will teach you the time when it cleans automatically.
But if you prefer not to use this function, it is possible to change the setting.
The Autoloader must be in maintenance mode to check or change the setting of this function.
5.1.2.1 Checking the CLNROL- function
The method of checking the CLNROL-function is described in this section.
Default CLNROL-function setting : Enable
Operation 1 Switch ON the power and wait for the completion of power-on test.
Display: READY and DRV empty are alternately displayed.
Operation 2 Press the ENTER key.
Display: STATUS
Operation 3 Press the arrow key and select the MAINTENANC command
Display : MAINTENANC
Operation 4 Press the ENTER key and define the command.
Display (line 1): PASSWORD
Display (line 2): 0000000000
Tip
If you press the allow key, the number is up or down. If you press the enter
key, the number is decided and the cursor move to the next digit. If you have made a
mistake, press the escape key. All number you have entered are canceled.
Operation 5 In this condition, press the ENTER key and set the above password.
Display (line 2): RCLN MODE?
Operation 6 Press the ENTER key and define the command.
Display (line 2): View?