Tandberg Data Autoloader Tandberg LTO2 - Manual (Page 84)

- 68 -
Panel Operation and Other Messages
Table-D7 Table of Panel Operation and Other Messages
Message Description
BUSY The transporter is operating.
Complete The executed command has normally completed.
door open The front door is open.
Dst.full There is (isn’t) a cartridge in the loading (ejection) destination slot.
err.BCR ini An error occurred during the initial inventory scan.
FATAL ERR.
The door has been forced open during the transporter operation and the magazine has been
removed.
ILLEGAL MODE Dip switch settings are not appropriate.
key unlock The door lock key is unlocked.
no magazine The magazine is not loaded.
NOT READY The Autoloader is engaged in the initial operation or an error has occurred.
Not Support An unsupported command has been received.
open ok Opening of the door is permitted.
OutOfRange The Autoloader detected an error during the Y axis operation.
READY The Autoloader is ready to operate.
REQ CLNROL Execute cleaning of the Roller.See”Section 5.1.2”
REQ. drv ID Resetting has been requested because the ID data of the drive in memory is abnormal.
REQ.RESET Resetting has been requested because the error restoration has been finished.
Reselect The same ID is set for the loader and drive SCSI ID settings.
SCSI P Err The Autoloader detected SCSI parity error.
SCSI Reset The Autoloader detected SCSI reset.
SRC.empty There is (isn’t) a cartridge in the loading (ejection) destination drive.
S10 forBCR Remove the cartridge from slot 7. Slot 10 is a free slot for the TD LTO2 Autoloader w/BCR.
wait. . Waiting for authorization to open the door.