Tandberg Data Autoloader Tandberg LTO2 - Manual (Page 7)

- v -
Cautions for installing, transporting, storing, and connecting
CAUTION
Do not lift the device alone.
This device weights 18 kg. Lifting it alone may injure your back. Be
sure to transport or move the device with two persons.
Do not install in location other than the one specified.
Do not install this device in the location listed below or other than the
location specified in this manual as a fire may occur.
Dusty place
Humid place such as near a hot water supply
Install where exposed to direct sunlight
Unstable place
Do not cover the air inlet
Do not cover the fan on the back panel and air inlet on the front panel
of the device as internal temperatures will rise, resulting in a fire or
an electric shock as well as operation error.
Do not connect/disconnect the interface cable with the plug still
inserted in the outlet.
Remove the power cable from the outlet before
connecting/disconnecting the interface cable. Touching cables or
connectors while the power cable is connected may lead to an electric
shock or a fire due to a short-circuit, even if the power is OFF.
Do not use an interface cable other than the one specified.
Use an interface cable specified by TD and connect it after
checking the device or connector. Using an interface cable other than
the one specified or connecting the cable to the wrong connection
point may lead to a fire due to a short-circuit.
Follow the instructions described below for handling and connecting
the interface cable.
Do not step on the cable
Do not place items on the cable
Do not use the device with the cable connected loosely
Do not use a damaged cable
Do not use a damaged cable connector
Be sure to lock the fastening screws