Tandberg Data Autoloader Tandberg LTO2 - Manual (Page 69)

- 53 -
5.2 Movement and Shipping of the Autoloader
Follow the procedure described below when moving or shipping the Autoloader.
Important
When shutting the System, see "2.7 Start and Shut Down of the System".
1. Check that the drive does not contain any cartridges.
2. If there are any cartridges in the drive, eject them. Refer to the manual for the backup
software or use the front panel keys. (See "3.5 Operation of Panel Keys" for details.)
3. Remove all cartridges from the Autoloader.
Important
Do not switch off the power of the Autoloader until the interface is in an
inactive condition. If the power of a SCSI peripheral device is switched off
while the bus is in an active condition, data may be lost or the condition of the
bus could become unstable. When the computer is connected to a LAN, be
certain to contact the system administrator before switching off the power.
4. Switch off the power of the Autoloader.
5. Disconnect the AC power cable, the SCSI cable, and the terminating resistance connector.
6. House the magazine, and lock the door.
Tip
When shipping this device, please pack it using the original packaging
materials and box. If these packaging materials are not available, pack the
device using cushioning material so that the device is not subjected to shock at
time of shipping.