Tandberg Data Autoloader Tandberg LTO2 - Manual (Page 73)

- 57 -
Error code Cause Recovery Procedure
The Autoloader detected an error during
ejection of the cartridge from the drive.
Execute cleaning of the Roller.See”Section 5.1.2”
If the phenomenon has a relapse,contact your
nearest Customer Support Center.
The Autoloader detected a
communicating error with the drive. Switch off the power of the Autoloader and then
switch the power back on.
The Autoloader detected an error during
loading of the cartridge to the drive.
The Autoloader detected an error during
ejection of the cartridge from the fixed
slots.
The Autoloader detected an error during
ejection of the cartridge from the
magazine.
The Autoloader detected an error during
loading of the cartridge to the fixed
slots.
The Autoloader detected an error during
loading of the cartridge to the
magazine (i.e. putting operation).
Execute cleaning of the Roller.See”Section 5.1.2”
If the phenomenon has a relapse,contact your
nearest Customer Support Center.
An error that occurred during the
operation of the (optional) bar code
reader.
Check whether there is a cartridge in slot 10.
Check whether there is any foreign matter in the
magazine or transporter.
Switch off the power of the Autoloader and then
switch the power back on.
The Autoloader detected an error during
error restoration. Switch off the power of the Autoloader and then
switch the power back on.
The Autoloader detected an error during
the Y move system initialization.
Check whether there is any foreign matter in the
transporter.
Switch off the power of the Autoloader and then
switch the power back on.
The Autoloader detected an error during
Initialize Element Status command
execution from SCSI.
Check whether there is any foreign matter in the
transporter.
Switch off the power of the Autoloader and then
switch the power back on.
The Autoloader detected an error during
the Y move of the transporter.
Check whether there is any foreign matter in the
transporter.
Switch off the power of the Autoloader and then
switch the power back on.