Tandberg Data Autoloader Tandberg LTO2 - Manual (Page 42)

- 26 -
3.6 Setting the SCSI ID
This command sets the SCSI ID of the Autoloader in conjunction with SCSI devices such as the
server/workstation that is to be connected.
The following SCSI IDs are assigned to this device as default values prior to shipping from the
factory.
SCSI IDs at time of factory shipping:
• Tape drive : (1)
• Autoloader : (0)
Important
The Autoloader and the tape drive must each have an independent SCSI ID.
This device has a specification that does not allow duplication of the tape drive
and Autoloader IDs. Please check that the IDs of other SCSI devices on the
same SCSI bus do not duplicate the IDs of the tape drive and the Autoloader.
Checking the SCSI ID and the method of changing it are described in this section.
3.6.1 Checking the SCSI ID
Operation 1 Switch ON the power and wait for the completion of the power-on test.
Display: "READY" and "DRV empty" are alternately displayed.
Operation 2 Press the ENTER key.
Display: STATUS
Operation 3 Press the arrow key and select the "SCSI ID" command .
Display: SCSI ID
Operation 4 Press the ENTER key and define the command.
Display; View ID?
Operation 5 Press the ENTER key and define the command.
Display: L.0 D.1
Tip
When checking the SCSI ID, the Autoloader is displayed as "L" and the tape
drive as "D".