Uniden BCT15 - Manual (Page 104)

104
Edit Srch Limit — lets you view and select the frequency ranges to search.
The scanner prompts you to enter the upper and lower search limits.
Set Delay Time — lets you set the amount of time the scanner will delay before
continuing to search after a transmission ends.
Set Modulation — lets you set the custom search range’s modulation type.
Set Attenuator — lets you set whether the scanner will attenuate reception by
20 dB during search.
Set Data Skip — lets you set whether the scanner will skip data transmissions
during search.
Set Step — lets you set the custom search range’s step (the gap between
frequencies).
Set C-Ch Only — lets you search for a Motorola control channel. If it finds one,
the scanner scans the system.
Set Record — if during your listening to the selected service, if a transmission is
received, choosing On sends an audio signal to the connected audio recording
device.
Search with Scan — sets whether the scanner includes the custom search
during scanning. If unlocked, the scanner first scans all selected systems, then
searches the selected service searches for the selected hold time (0-255
seconds).
Within the Search With Scan menu listing are the following settable options
Set Quick key — lets you assign a Quick Key for the custom search range.
Set Startup Key — lets you decide which custom search range should be
unlocked and scanned at power up
Set Lockout — lets you lock the custom search range for this session or
permanently as with any other L/O action.
Set Hold Time — sets how long (seconds) the custom search range is checked
before the scanner moves to the next programmed entry.
Search With Scan
When you press [SCAN/SEARCH] the BCT15 starts a scan of those sites,
channels, etc you have manually programmed that are unlocked and have their
System Quick key enabled.