Uniden BCT15 - Manual (Page 45)

45
Controls, Keys, and Functions
6. GPS (Global Positioning Satellite) Key
• Press to switch to GPS mode.
• Press and hold to store current location data with a connected and enabled
GPS.
7. L/O Key
• Press once to temporarily lockout a system channel, a search frequency, or
location data. The temporary lockout is cancelled when you turn off power.
• Press twice rapidly to permanently lockout a system channel, a search
frequency, or location data. The permanent lockout remains in effect until you
purposely unlock that channel, frequency, etc.
Note: this does not apply to a TGID found during an ID Search using the
BearTracker system.
• Press and hold while in Scan or Scan Hold mode to unlock all locked values in
the current system.
• Press and hold to unlock location data in Review Location (GPS) mode.
• Press and hold to unlock all the frequencies of all Search Ranges in Search
mode and Close Call mode.
8. [1] to [9] and [0] Key
• In Scan mode, press the numeric keys to access a set Quick Key for a system
or search range.
• In Custom Search mode, press numeric keys to enable or disable a specific
search range number, applicable only to the search range.
• In All Hold, Close Call, and Tone-Out modes, press the numeric keys to switch
to Direct Entry mode.
• When editing a name, press [4] to move the cursor one character to the left.
Press [6] to move the cursor one character to the right.
9. [.No] Key
• Press to cancel an Error or Warning message.
• Press to input the decimal point for a frequency.
• Press to enter a hyphen when inputting a Talk Group ID.
• Press to enter an ‘i’ as the first character of an I-Call (Individual Call) in Hold,
Close Call Only, and Tone-Out modes.
• Press to enter numeric values for the tens place for a Quick Key.