Uniden BCT15 - Manual (Page 68)

68
[MENU] Set Bear Tracker
F
Set Hold Time
F
Set the hold time, in seconds, between 0 and 255.
Use to change the number position.
If you exceed 255, and press
F
, you see
Out of Range, Set Max? (Y/N)
If you want to use the maximum setting, press
F
.
If not, press [.No] to cancel and enter a new number in range.
Set Delay Time
This setting determines how long the scanner remains on channels of a system
after the transmission ends before resumes scanning.
[MENU] Set Bear Tracker
F
Set Delay Time
F
Set the delay time, in seconds, between 1 and 5 and Off.
Then press
F
to make your selection.
Set Attenuator
This setting lets you introduce about 20dB attenuation to a strong signal.
[MENU] Set Bear Tracker
F
Set Attenuator
F
to select either On or Off then
F
to set your selection.
Set Alert Level
This setting lets you choose a volume level for the selected Alert Tone.
[MENU] Set Bear Tracker
F
Set Alert Level
F
to select a level between 1 and 15 (loudest) or Auto which matches the volume
of your master volume control.