Uniden BCT15 - Manual (Page 83)

83
Programming Your Scanner
Off — the scanner ignores I-Calls. The default setting is Off.
Only — the scanner only tracks I-calls and ignores other radio traffic on the
system. Press
F
to select.
Note: You can enter a wildcard that matches all I-calls by programming [.No] + [0]
into one of the channels. When you press [.No] the scanner interprets the entry as
a ‘i’ so that the entire entry can be written “i0.”
[MENU] Program System
F
Select a Motorola Type I, II or EDACS Wide/Narrow system
F
Edit Sys Option
F
Emergency Alert
F
Off — the scanner does not alert you to emergency transmissions.
Alert 1 - 9 the scanner sounds an alert beep to notify you of the emergency
transmission. The default alert is Off. You can choose any of 9 different beep
types. Once you choose an alert tone, next:
Set Level
F
Auto — the scanner automatically sets the emergency alert beep to the master
volume level.
Level 1 - 15 — the scanner adjusts the volume you hear to the level you select.
Assigning a Conventional System to a State
In addition to the BearTracker System Preprogrammed State information, you may
want to program another system in that same state. Then, when you turn on that
state using the [STATE] and the Scroll Control, the system you program will also
be enabled and scanned. See “Assigning a Trunked System to A State” after
“Setting Site location Information”
[MENU] Program System
F
Select an existing Conventional system type
F
Edit Sys Option
F
Set State
F
Rotate the Scroll Control to the same state as the system’s state.
Setting the Emergency Alert Option ME
Conventional Systems C