Uniden BCT15 - Manual (Page 131)

131
Using the BCT15 with a GPS
For POI Only
Set Alert Beep
F
Choose Off so no tone sounds or one of the four
alert melodies Alert 1 to Alert 4.
Once you make a Tone selection you are immediately asked to assign a volume
level to that selection.
Set Alert Volume
F
Select from 15 sound levels, plus Auto. As you rotate
the Scroll Control the Alert tone you set is played louder and louder. Press
F
to
select a volume level. You can also select Auto, a level that is the same setting as
your master volume control.
Set Range
F
Input how far away the alert sounds for the site (only
available for POI’s and between 0.1 and 2.0 miles)
For Dangerous Xing, and Dangerous Road Only
The Alert Tone is fixed. The alert range is auto-set at 0.5, 0.25, and 0.1 mile.
Set Alert Volume
F
Select from 15 sound levels, plus Auto and Off. As
you rotate the Scroll Control the Alert tone is played louder and louder. Press
F
to select a level you want. You can also select Off (no sound) or Auto, a level
that is the same as your master volume control.
An Example of a POI Alert
The Uniden America Corporation is
located at 4700 Amon Carter Blvd
in Ft. Worth, TX. The Latitude and
Longitude of the front entrance is
32° 50’00.63” N and 97°02’54.16”
W.
When you program that data as a
POI, you can select alert ranges of
0.1, 0.25, 0.5, 0.75, 1.0, 1.5, and
2.0 mile distances to the POI.
Shown on the map are 0.5 and 1.0
mile markers.
You are alerted when you come
within range of your set distances.