Uniden BCT15 - Manual (Page 88)

88
Edit Site
F
Select a Site
F
Set Startup Key
F
Select a startup key from [0] to [9] or select “.” for no startup key.
Notes:
• To unlock the system at startup, press and hold the selected startup key while
you turn on the scanner.
• The system Quick Key is also enabled.
• If you press a different key at startup, the system is locked out.
• If you do not assign the system a startup key, the system is not affected by any
key press during startup.
[MENU] Program System
F
Select a trunked system
F
Edit Site
F
Select the site
F
Set Frequencies
F
New Frequency (or select an existing frequency)
F
Input a system frequency using the number keys and [.No] key, then press
F .
If
you are entering frequencies for an LTR or EDACS system, the scanner will also
prompt you to enter the LCN for the frequency you just entered. LCN’s (logical
channel numbers) are provided from the same source where you got the other
system information.
To enter additional frequencies, press [MENU], then to select New
Frequency . Then repeat the above.
Note: If you select Control Channel Only mode (see “Setting Control-Channel
Only (Motorola Systems Only)” on Page 91), you only need to enter the
frequency(s) that can be assigned as the control channel. Most frequency lists
usually indicate which of the frequencies are the control channel frequencies.
Otherwise, you must enter all of the frequencies.
[MENU] Program System
F
Select a trunked system
F
Edit Site
F
Setting Site Frequencies MESL
Setting Site Modulation ML