Uniden BCT15 - Manual (Page 91)

91
Programming Your Scanner
[MENU] Program System
F
Select a trunked system
F
Edit Site (current)
F
Select a site
F
Set C-Ch Only
F
This setting determines the frequencies you need to enter for Motorola systems.
Select your setting, then press
F .
On — You only need to enter control channel frequencies.
Off — You must enter all voice and control channel frequencies.
Note: The scanner defaults to On.
[MENU] Program System
F
Select a trunked system
F
Edit Site (current)
F
Select a site
F
Set LocationInfo
F
This setting control whether the system is automatically enabled and disabled
when you connect a GPS to the scanner.
Set Latitude — Enter the system’s latitude using the format you selected in the
system settings.
Set Longitude — Enter the system’s longitude using the format you selected in
the system settings.
Set Range — Set the system’s range using the units you selected in the system
settings.
Set GPS Enable — Depending on the data received from the GPS, the L/O
status of the site is automatically controlled .
Assigning a Trunked System to A State
In addition to the BearTracker System Preprogrammed State information, you may
want to program another system in that same state. Then, when you turn on that
state using the [STATE] control and the Scroll Control, the system you program
will also be unlocked and scanned.
Setting Control-Channel Only Mode M
Setting Site Location Information MESL