Uniden BCT15 - Manual (Page 72)

72
3b. (Slave scanner) Clone Slave Press SCAN Key [SCAN/SEARCH]
Clone Slave Connecting
4. When you are ready to clone the scanner, press [SCAN/SEARCH] on the
slave scanner first, then [SCAN/SEARCH] on the master scanner. The
master scanner checks the connection between the two scanners, then
transfers its data to the slave scanner.
5. When the transfer is complete, Complete appears on both scanners. If the
transfer did not work, Error appears on the master scanner. Readjust the
baud rate to a lower setting and try again.
Start of Transfer
During Transfer
Press [L/O] on the Master unit to exit Clone mode.