Uniden BCT15 - Manual (Page 44)

44
• Use this combination in any mode except Scan and GPS. Press [3] to toggle
Close Call mode. Press and hold [3] to switch to Close Call Only mode.
• Use this combination in any mode except Scan and GPS. Press [4], [5], or [6]
to begin searching the range set when you set up and assigned one of these
keys to a selected search range.
• Use this combination in any mode except Scan and GPS. Press [7] to toggle
the attenuator setting.
• Use this combination in Scan Hold, Search, Search Hold, Close Call Only, and
Close Call Hold modes. Press [8] to monitor the frequency to the site repeater.
The scanner changes back to the frequency from the repeater when you
release [8].
• Use this combination in any mode except Scan and GPS. Press [9] to set Alert
Plus Scan on.
• Use this combination in Scan Hold mode. Press [0] to toggle Name Disp mode
on or off.
F
+ [.No] Key
• Use this combination in Scan and Scan Hold mode to toggle the Active
Channel Display mode on and off.
F
+ [SCAN/SEARCH] Key
• Use this combination in Search Hold mode or monitoring in Search mode. Use
to resume searching.
• In all other modes except Search, Search Hold, and GPS, press
[SCAN/SEARCH] to display Quick Search Prompt.
• Use this combination while scanning a trunked system to toggle ID Scan and
ID Search.
Note: This does not work while scanning Bear Tracker system.
4. POL/DOT Key
• Press to change the group lockout status of Police, Department of
Transportation. Unlocked means enabled for scanning. See the table on
Page 58 for the result of multiple key presses.
5. HP/
B
®
BT (BearTracker™) Key
• Press to change the group lockout status of HP (Highway Patrol), and
B
BearTracker™. Unlocked means enabled for scanning. See the table on
Page 58 for the result of multiple key presses.