Ultimate Technology 600 POS - Manual (Page 21)

Series 600 POS Keyboard
16
Table 2. Local Mode Programming Instructions
* = Default Settings
Function Code(s) Operation Normal Indication Remarks
08
Enable/Disable
Magnetic Stripe
Reader (MSR)
Tracks
1. Swipe Program Card. While in programming mode, at the Series 600 Keyboard
numeric keypad, enter Function Code 08.
LED (2) turns on.
2. At the Series 600 Keyboard numeric keypad, enter the applicable number (1 through
7) to select the MSR track configuration per list below.
1 = Track 1 enabled only
2 = Track 2 enabled only
3 = Track 3 enabled only
4 = Tracks 1 and 2 enabled *
5 = Tracks 2 and 3 enabled
6 = All tracks disabled
7 = OPOS mode tracks 1 and 2
LED (2) turns off.
3. Program the next function code or exit the local programming mode by entering 99 on
Series 600 Keyboard numeric keypad or by swiping the Program Card.
Note: Disabling all format tracks will not disable the SECURE or PROGRM cards.
09
Magnetic Stripe
Reader (MSR)
Beeper
1. Swipe Program Card. While in programming mode, at the Series 600 Keyboard
numeric keypad, enter Function Code 09.
LED (2) turns on.
2. At the Series 600 Keyboard numeric keypad, enter the applicable number (1 through
4) to select the magnetic stripe reader beeper operation per list below.
1 = beep on good read for all enabled tracks
2 = beep on bad read for all enabled tracks
3 = beep on good or bad read of enabled tracks*
4 = no beep on good or bad reads
LED (2) turns off.
3. Program the next function code or exit the local programming mode by entering 99 on
Series 600 Keyboard numeric keypad followed by ENTER or by swiping the Program
Card.