Ultimate Technology 600 POS - Manual (Page 35)

Series 600 POS Keyboard
30
LOCAL MODE PROGRAMMING
KEY MAKE/BREAK CODES AND EXTENDED FUNCTIONS
A summary of all keyboard parameters programmable in the local mode, assigned Function
Codes and factory default settings is given in Table 3.
Table 3. Local Mode programming Function Codes and Default Settings
FUNCTION
CODE
PARAMETER DEFAULT
SETTING (XXh
= Hex Code in
ASCII)
REMARKS
00 Program Keyboard Primary Keys See default
(Appendix A) Used to program primary keys on
Series 600 Keyboard. The keys can
be programmed to have primary and
secondary levels of function. The
primary function is activated when only
the designated key is pressed. The
secondary function is activated when
both the Sec Op key and designated
key are depressed. Use Function
Code 01 to program secondary key
functions.
01 Program Keyboard Secondary
Keys See default See remarks above.
02 Copy Primary Keys to Secondary
Keys None Used to copy primary key code into
key secondary position
03 Program Primary OPOS Keys None To be used in conjunction with UTC
OPOS drivers.
04 Program Secondary OPOS Keys None To be used in conjunction with UTC
OPOS drivers
08 Enable/Disable Magnetic Stripe
Reader (MSR) Tracks Channels 1,2
enabled The magnetic card reader can read
three formats of information, two at
any one time, on standard format
cards. This function is used to select
which tracks on the MSR are enabled
and/or disabled.
09 MSR Beep Configuration Beep on good
and bad read Useful for indicating a good or bad
reading when card swiped through
reader. (Uses different tones)
10 MSR Track 1,3 Prefix % (25h) for
format 1
;(3Bh) for
format 3 Used to send a prefix before the
magnetic card track data.
11 MSR Track 1,3 Field Separator ^(5Eh) for
format 1 =
(3Dh) for
format 3 Used to send a field separator
between fields of magnetic card data.