Ultimate Technology 600 POS - Manual (Page 54)

Series 600 POS Keyboard
49
Table 5. Remote Programming Mode Commands
OP CODE
(HEX)
MNEMONIC/DESCRIPTION COMMAND/ACKNOWLEDGEMENT
B3 RDERROR
Sends all error information to main port for
output.
COMMAND: B3<CR>
B3
= Op Code
<CR> = terminate command (0D hex)
Sends all error log information contained in the non-
volatile memory (NVRAM) out the main port.
ACKNOWLEDGEMENT: NONE
B4 COMMIT
Writes programming changes to the
NVRAM. Always apply the COMMIT
command after programming the keyboard
to save the changes in the NVRAM.
Failure to use the COMMIT command will
result in the loss of the changes the first
time power is removed from the keyboard.
COMMAND: B4<CR>
B4
= Op Code
<CR> = terminate command (0D hex)
ACKNOWLEDGEMENT: NONE
B5 RESET
Resets keyboard after downloading
configuration. On receipt of this command
the unit does a warm boot.
COMMAND: B5RST<CR>
B5
= Op Code
<CR> = terminate command (0D hex)
ACKNOWLEDGEMENT: NONE
B6 KSSND
Used to select when keyswitch 1, 2 or 3
MAKE/BREAK codes are sent. Two
options are available: unsolicited mode
where codes are sent whenever the
keyswitch is rotated, or solicited mode
where codes are sent only when a OP
Code B7 command is received.
COMMAND: B6<CR>
B6
= Op Code
x A = unsolicited
B = solicited
<CR> = terminate command (0D hex)
ACKNOWLEDGEMENT: NONE