Ultimate Technology 600 POS - Manual (Page 33)

Series 600 POS Keyboard
28
Table 2. Local Mode Programming Instructions
* = Default Settings
Function Code(s) Operation Normal Indication Remarks
84
85
Define Left
ALTERNATE
Key (84) and
Right ALTERNATE
Key (85)
1. Swipe Program Card. While in programming mode, at the Series 600 Keyboard
numeric keypad, enter Function Code 84 or 85.
LED (2) flashes.
2. At the auxiliary keyboard, hit the left ALTERNATE key if programming Function Code
84 or right ALTERNATE key if programming Function Code 85.
3. At the Series 600 Keyboard, press ENTER.
LED (2) turns off.
4. Program the next function code or exit programming mode by entering 99 on Series
600 Keyboard numeric keypad or by swiping the program Card.
90
Dump System Log
This is a command used to read out the Series 600 Keyboard system log data at the main
port. For detailed information about retrieving the system log data, refer to the
Maintenance Section of this manual.
91
Main Port Select
1. Swipe Program Card. While in programming mode, at the Series 600 Keyboard
numeric keypad, enter Function Code 91.
LED (2) turns on.
2. At Series 600 Keyboard numeric keypad, enter the applicable number.
0 = Keyboard Port 0 is main
1 = RS232 Port 0 is main
2 = Keyboard Port 0 is main, but RS232 Port 0 will accept commands
LED (2) turns off.
3. Program the next function code or exit programming mode by entering 99 on Series
600 Keyboard numeric keypad or by swiping the Program Card.
Note: Must re-power Series 600 Keyboard in order to activate function code.