Ultimate Technology 600 POS - Manual (Page 55)

Series 600 POS Keyboard
50
Table 5. Remote Programming Mode Commands
OP CODE
(HEX)
MNEMONIC/DESCRIPTION COMMAND/ACKNOWLEDGEMENT
B7 KSSTATUS
Send keyswitch MAKE/BREAK codes in
current keyswitch 1, 2 or 3 position.
COMMAND: B7<CR>
B7
= Op Code
<CR> = terminate command (0D hex)
ACKNOWLEDGEMENT: NONE
B8 MSRSND
Use to send magnetic card reader track
data for any one good track or if both
tracks are good.
COMMAND: B8x<CR>
B8
= Op Code
x A = send any good track
B = send if both tracks are good
<CR> = terminate command (0D hex)
ACKNOWLEDGEMENT: NONE
B9 CARDED
Enables or disables tracks on magnetic
card reader.
COMMAND: B9c<CR>
B9
= Op Code
c = track selection
<CR> = terminate command (0D hex)
Track selection:
A
= track 1 on
B = track 2 on
C = track 3 on
D = track 1 and 2 on
E = track 2 and 3 on
F = all tracks off
I = OPOS track 1 and 2 on
J = OPOS track 2 and 3 on
ACKNOWLEDGEMENT: NONE