Ultimate Technology 600 POS - Manual (Page 26)

Series 600 POS Keyboard
21
Table 2. Local Mode Programming Instructions
* = Default Settings
Function Code(s) Operation Normal Indication Remarks
24 or 34
Main Port 0 (24)
AUX Port 1 (34)
Word Length
1. Swipe Program Card. While in programming mode, at the Series 600 Keyboard
numeric keypad, enter Function Code 24 (Port 0) or 34 (Port 1).
LED (2) turns on.
2. At Series 600 Keyboard numeric keypad, enter the applicable number (7 or 8) to
select word length per list below.
7 = 7 data bits
8 = 8 data bits*
LED (2) turns off.
3. Program the next function code or exit programming mode by entering 99 on Series
600 Keyboard numeric keypad or by swiping the Program Card.
25 or 35
Comm (RS232)
Main Port 0 (25)
AUX Port 1 (35)
Prefix
1. Swipe Program Card. While in programming mode, at the Series 600 Keyboard
numeric keypad, enter Function Code 25 (Port 0) or 35 (Port 1).
LED (2) flashes.
2. At the auxiliary keyboard, press the desired key or type the desired key sequence.
Note that the maximum number of key codes is limited to 24 – this is equivalent to
approximately 12 key strokes.
If the Series 600 Keyboard beeps and
LED (2) turns off while entering key
codes at the auxiliary keyboard, you
have exceeded 24 key codes.
Repeat steps 1 and 2.
3. At the Series 600 Keyboard, press ENTER.
LED (2) turns off.
4. Program the next function code or exit programming mode by entering 99 on Series
600 Keyboard numeric keypad or by swiping the Program Card.