VEGA VEGAPULS 51V…54V - Manual (Page 58)

58 VEGAPULS 51 V … 54 V
Set-up - Adjustment with the PC on VEGAMET
In the following figure you see the echo curve
before correction of the installation angle
(directing to the product surface) with a false
echo which has nearly the same size than the
product echo and which is caused by a strut.
In the next figure you see the echo curve
after optimum directing of the sensor to the
product surface (sensor axis vertically to the
product surface).
You see that the false echo caused by the
strut is here reduced by approx. 20 dB
against the useful echo and hence can no
more influence the measurement.
• Quit the menu window "Echo curve" with
" Quit".
With the menu point " False echo storage" in
the menu window " Sensor optimisation" you
can cause the sensor to mark false echoes.
The sensor electronics then saves the false
echoes in an internal database and treats the
false echoes at a poorer degree than the
useful echo.
• Click in the menu window " Sensor
optimisation" to the menu point "False echo False echo False echo False echo False echo
storage storage storage storage storage".
• Click in the menu window " False echo
storage" to "Learn false echoes Learn false echoes Learn false echoes Learn false echoes Learn false echoes". The small
window " Learn false echoes" opens.
• Enter here the checked product distance
and click to " Create new Create new Create new Create new Create new".