VEGA VEGAMET 514 - Manual (Page 18)

18 VEGAMET 514
Setup
5 Setup
• Adjust the VEGAMET instrument address
on the circuit board by means of the rotary
switch (only necessary, if several
VEGAMET are connected by means of
DISBUS).
• Install VEGAMET.
• Connect sensor and power supply.
• After switching on, the display indicates for
approx. 10 secs the instrument type and
the software version, e.g. "MET 514
V1.12".
• If a measurement loop has not yet been
configured, the display shows "Configura-
tion", the red failure LED also lights. In this
case, proceed as described under "6.1
Configuration of measurement loop".
• If a measurement loop is already
configured, the display shows a value, e.g.
"TAG-No. 1 21.8 %".You can now carry out
the settings, as described in the chapter "6
Settings in the reduced menu".