VEGA VEGAPULS 81 - Manual (Page 58)

58 VEGAPULS 64 and 81
Set-up: Adjustment with PC
Now the picture “ Create new measurement
loop – Measurement loop designation“.
• Click to the button “ Distance“.
• Enter in the field “ Measurement loop de-
scription“ a measurement loop name.
In this menu you can chose with which output
signally your level should be processed, e.g.
as current, voltage, relay, circuit etc.
• Confirm with “ OK“.
The previous picture appears again.
• Click to “ Quit“.
The adjustments are transmitted, this lasts
some seconds.
Parameter adjustment
You have created a new measurement loop in
the previous chapter. Hence you have chosen
the measuring principle, co-ordinated the
sensor with its number to an input, to provide a
name for the measurement loop and if neces-
sary determined by which outputs (current,
relay etc.) your measuring signal/sensor signal
should be processed.
Now the parameter adjustment for the sensor
must be carried out. Enter in the menu “Pa-
rameter adjustment“ how the conditionings
and outputs will be configured, carry out the
adjustment and the sensor optimization.
Following the menus “Adjustment“ and “Sen-
sor optimization“ are described. The other
parameter menus are described in the operat-
ing instructions of the signal conditioning
instruments VEGAMET 514 V or 515 V, as well
as the processing system VEGALOG 571 and
concern just the signal processing of your
measured value.
• Choose the menu “ Instrument data/
Parameter adjustment“.