VEGA VEGAPULS 81 - Manual (Page 73)

VEGAPULS 64 and 81 73
6.5 Menu survey to the signal
conditioning instrument
Configuration (main menu stage)
–– Configuration inputs
–– Input 1
–– Input of
–– Serial no. XXX
––
Sensor values (Info)
––
Sensor optimization (A)
(A) see previous pages
–– Input 2 as input 1
–– Input 4
–– Input of
–– Channel no.
–– Configuration measurement loops;
Choice: linked or single application
–– MST1 … MST3
–– Application
–– Sensor/Input
–– Type (Standard)
–– Option
–– Sensor co-ordination (A, B, C)
–– MST-Name, MST1
(provide a name with “+, –, ← , → “)
–– Fault signal
–– Tare
–– Monitoring
–– MST2 as MST1
–– MST3 as MST1
–– Instrument address
(deleted up from software version 6,0)
Set-up: Adjustment with signal conditioning instrument
You have carried out the sensor optimization
for measurement loop 1. Now quit the menu
“ Sensor optimization“.
ESC Sensor optimization
ESC Input no. 1
Note:
If you have connected a second radar sen-
sor to input 2 (VEGAMET 515 V) also carry
out the configuration and sensor adaption
for this sensor.
→ Input 2
OK Input of this MET
Now carry out the adjustment for measure-
ment loop 2, like for measurement loop 1,
this also means under the menus “ Configu-
ration inputs“ and “Sensor optimization“.
You have hence configured the inputs and the
measurement loop in the menu “ Configura-
tion“. In this main menu you must also
configure the outputs.
In the main menu “ Parameter adjustment“ you
determine by which parameters (min., max.,
scaling) your measuring signal should be
processed. The menu survey is on the follow-
ing pages. Further instructions are stated in
the operating instruction of your signal condi-
tioning instrument.