GE Industrial Solutions Galaxy Vector Controller GCM3 User Manual
Galaxy vector controller gcm2, gcm3
Advertising
Table of contents
Document Outline
- Galaxy Vector Controller GCM2, GCM3
- Table of Contents
- List of Figures
- List of Tables
- Introduction
- Product Description
- Operation
- Installation and Configuration
- Wiring
- Front Panel Operation
- Configuration
- Battery Discharge Test Results
- Battery Discharge Test Enable
- Shunt Type/Size
- Shunt Size
- System Float Mode Settings
- Very Low Voltage Threshold
- Battery Recharge Current Limit Settings
- Battery Thermal Compensation Settings
- Low Voltage Disconnect Contactor 1 and 2 Settings
- Plant Boost Mode Settings
- Converter Settings
- Voltage Calibration
- Reserve Operation Engine
- Serial Bus Updating and Clearing
- Software Release Information
- Troubleshooting
- Replacing Circuit Packs
- Checking the highest battery temperature
- Inaccurate Plant Voltage Readings
- Temperature Probe Alarm is present
- Unexplained Rectifier Failure Alarm and Multiple Rectifier Failure Alarm
- Unexplained Converter Failure Alarm and Multiple Converter Failure Alarm
- Rectifier Id conflict alarm is asserted
- Converter Id (Cid)
- Product Warranty
- Communications
- Modem
- Galaxy Gateway
- Introduction
- Preparation
- Precautions
- Tools/Equipment Required
- Unpacking the Galaxy Gateway
- Vector Controller Configuration
- Gateway Installation for Vector Controller
- Galaxy Gateway Cable Connections
- Configuring Network Communications
- Logging In to the Galaxy Gateway
- Configuring Static Network Parameters
- Logging Out of the Galaxy Gateway
- Post Installation Procedures
- T1.317 Objects and Attributes
- Regulatory Statements