GE Industrial Solutions Galaxy Vector Controller GCM3 - Manual (Page 85)

Item Qty Comcode Description
1 1 108340100 Galaxy Gateway circuit pack
2 1 848281945 Black insulator (not used)
3 1 848364865 Millennium Controller interface cable (not used)
4 2 408456465 Nylon mounting posts (HMSP-TM-10)
5 1 402244081 Cable tie
6 2 407882141 Metal standoff (9740-SS-0632)
7 2 845143866 Screw, PPHM 6-32 x 5/16"
8 1 848589859 Black insulator
9 1 848575841 Vector Controller interface cable
10 4 408450955 Metal standoff (AL-5171-16)
11 8 901377366 Screw, PPHM M3 x 6mm
12 4 901351239 Nut, hex 6-32
13 1 848649943 Mounting bracket
Galaxy Vector Controller GCM2, GCM3
Issue 4 January 2008 Communications Appendix A - 7
If damage is found and/or components are missing, file a claim
with the carrier if applicable, and notify Lineage Power
Customer Service (See Section 1).
Vector Controller
Configuration
The physical interface for the Vector controller to the Galaxy
Gateway is through P4 connector on the BLJ terminal
connection board, close DIP switch S1.3 (set to 1) to allow
communication between Gateway and the Vector Controller.
Gateway
Installation for
Vector Controller
Use the following procedure and Figures A-2a and A-2b to
install a new or replacement Galaxy Gateway on a GPS metal or
plastic (DA) door.
1. Install 848649943 bracket to metal door and secure with
two 901351239 hex nuts (6-32) per Figure A-2a or install to
plastic door and secure with three 901377366 screws per
Figure A-2b.
2. Place 848589859 black insulator under the Galaxy Gateway
and position over the mounting standoffs so that J1 (RJ-45
network interface connector) and J2 (DB-9 serial port
connector) are facing down. The component side of the
circuit pack should be facing outward.
3. Install two 408456465 nylon mounting posts to the lower
mounting standoffs (torque to 3 in·lbs).