GE Industrial Solutions Galaxy Vector Controller GCM3 - Manual (Page 87)

Figure A-3: Gateway Connection to BLJ3 Terminal Board.
P1
J2
EBW1
BLJ
RS-232
Power
DG
ABS
J1
Network
Connection
P4
Galaxy Vector Controller GCM2, GCM3
Issue 4 January 2008 Communications Appendix A - 9
10Base-T Network
The Galaxy Gateway has an IEEE 802.3 compliant 10Base-T
network interface. Since the cable length required to connect the
Galaxy Gateway to the network is variable, this cable must be
supplied by the user. Connect the network interface cable from
the IEEE 802.3 compatible network to J1 (RJ-45) connector on
the Galaxy Gateway as shown in Figure A-3.
1. Connect one end of the network interface cable to J1 (RJ-45
Network Interface Connector), usually located at the bottom
right on the Galaxy Gateway. (Other configurations are
possible with the hardware shown in Figure A-3.)
2. Connect the other end to an IEEE 802.3 compatible
network.