GE Industrial Solutions Galaxy Vector Controller GCM3 - Manual (Page 80)

Galaxy Vector Controller GCM2, GCM3
Appendix A - 2 Communications Issue 4 January 2008
The controller communicates with the BSM3 internal modem
and an external modem at the same communication settings.
These settings are as follows:
baud rate: 2400
data bits: 8
stop bits: 1
parity: none
The controller communicates over the RS-232 terminal interface
using the following settings:
baud rate: 9600 default, auto baud from 1200 to
19200
data bits: 8
stop bits: 1
parity: none
Logging in This section describes how to log into the system. The first step
to logging in is to get to an "ENTER PASSWORD: " prompt.
From a modem, dial into the controller and wait for the modem
to connect. After the modem connects you will be presented with
the log-in prompt. If you don't see the log-in prompt after the
modem connects, you may have to press the ENTER key in
order to see the prompt.
From a terminal connected to the RS-232 port, simply press
ENTER until you are presented with the log-in prompt. The
number of ENTER keys required will depend on the baud rate
you are trying to connect at. The controller will adjust its baud
rate automatically until it recognizes the carriage return
character (ASCII 13) sent by pressing ENTER.
At the "ENTER PASSWORD" prompt type the user or super-
user password. The default password for each level of security is
listed below.
lineage default user password
super-user default super-user password
In general, the user and super-user may view any measurement,
configuration, or control parameter. The super-user can also set
configuration and control parameters as well as change system
passwords.