Xylem Magflux Electromagnetic Flow Meter - Manual (Page 45)

45
Electromagnetic Flow Meter
FW: 842018/842009
6. Pass through the "DN" menu and press OK.
Type Password
0000
Back Select >
Service Menu
Sensor Calibration Code
Converter SW Ver.
Product Data
Reset Counter Time
Internal Meas. & Cal.
Minimum Velocity
Calibrate Flow now
Calibrate Volume
Calibrate mA
Test Velocity
Freeze Coil
Read Event Log
Back On Stock
Back
Select OK
OK
Sensor Calibration Code Converter SW Ver. Product Data
Sensor Calibration Code
7V3RI0
Back Select > Back
Product ID
56136
Back Select >
Product type No.
0000207910
Back Select >
Track No.
00000
Back Select >
HW type No.
00000510250
Back Select >
OK
OK
OK
Reset Counter Time
Reset Counter 11
Systen Runtime 1632838
Since reset 426838
Runtime (days) 18
Back
Select OK
Internal Meas. & Cal.
View Vgate
Coil Current
View ADC Factor
Calibrate Vground
Calibrate Vref
View Vwater
View Raw ADC
View ADC Current
Back
Select >
Minimum Velocity
Minimum Velocity
0.100 m/
sec
Back Select >
View Vgate Coil Current
View Vgate
3624
Back Select >
Coil Current
148
Back Select >
View ADC Factor
4.89011
Back Select >
Calibrate ADC ground
2270
Back Select >
View ADC Factor Calibrate ADC Ground
Only f
or ter
minal use
Must not be surrended
A
B
C
D
E
Date Modification
Scale:
MJK AUTOMATION A/S
Byageren 7
DK-2800 Nñrum
Fax: +45 45 56 06 46
Tel.: +45 45 56 06 56 Date:
Constructor:
Part no.:
Software version
Skala for tegning
Menu system for MagFlux Converter
Converter Setup
Service Menu
2006 - 09 - 20
841010
LSP
View ADC Current View Raw ADC
View ADC Current
09593127.00000
Back Select >
Input noise 0.18%
Raw ADC 10791
Gain 4.000
Velocity 5.21656 m/sec
Flow 0.0055786500 m
3 /sec
Back Select >
View Vwater
0
Back Select >
View/Calibrate Vref
1208
Back Select >
View Vwater View/Calibrate Vref
DN
00025
Back Select >
OK
Calibrate Flow now
View flow now
0.0019816387 m
3 /sec
Back Select >
Set Flow Direction
Follow Arrow A
Follow Arrow B
<A ----------------------------- B>
Back Select OK
OK
Converter 842009-005
Build 7659
Build 719
Bootload 840020-002
Sensor Direction Test
The MagFlux ® is now configured with default settings and is ready for use.
Note: If the sensor has not been pre-configured from the factory with
a sensor calibration code, the calibration code procedure is
somewhat different form the just mentioned.
See the steps on the following page to configure a non-configured sensor
with a calibration code.