Extron Electronics MGP Pro Series User Guide User Manual
Page 17
Advertising
MGP Pro Series • Installation
11
3.
Locate the small corner notch on the lens cap, and slide the screwdriver between the
lens cap and the diffuser (see figure 9,
3
).
4.
Using a rotating motion of the screwdriver, carefully pry the two pieces apart (see
figure 9,
4
).
Figure 9.
Replacing a Button Label
5.
Lift out the transparent square label that you want to replace. You may need to use the
small screwdriver to gently pry the label out.
6.
Insert one of the new labels you created in step 1 into the clear button cap, align the
white diffuser with the cap, and firmly snap it into place.
7.
Gently, but firmly, press the reassembled button into place on the MGP Pro front panel.
8.
Repeat steps 1 through 7 as needed to relabel other buttons.
Advertising