Extron Electronics MGP Pro Series User Guide - Manual (Page 36)

MGP Pro Series • Operation 30
4. When finished editing the settings for the selected item, either press Next to display
the editing screen for the next item, or press Menu to exit serial and IP edit mode and
display the next menu (Advanced Configuration).
The following screens are provided for editing parameters:
• Serial Config: Configure the serial port by switching between RS-232 and RS-422,
and selecting the baud rate.
• Set DHCP Mode: Set DHCP to On or Off.
NOTE: DHCP must be off before you can edit the IP addresses.
• Set IP Address: Set the IP address.
• Set Gateway Addr: Set the gateway address.
• Set Subnet Mask: Set the subnet mask.
NOTE: The MAC address has no screen in this mode because it cannot be edited.
Advanced Configuration Menu
Use the Advanced Configuration menu to set the background color, turn blue mode on and
off, and select test patterns. You can also view the internal temperature of the MGP Pro and
reset the system to its factory default settings.
Figure 21. Advanced Configuration Menu Flow