Extron Electronics MGP Pro Series User Guide - Manual (Page 35)

MGP Pro Series • Operation 29
Comm./IP Configuration Menu
Use the Comm./IP Configuration menu to view and edit the serial communication port
configuration and the MGP Pro IP addresses. The Comm./IP Configuration menu consists
of two levels: view and edit.
Figure 20. Communication/IP Configuration Menu Flow
Viewing serial port and IP settings
When you first reach the Comm./IP Configuration menu, the view level is displayed. At this
level, all the screens that you cycle through by pressing Next show the current settings. The
Adjust knobs are disabled and you cannot make changes from the screens.
To view the serial port and IP settings:
1. Press Menu repeatedly until COMM./IP CONFIGURATION is displayed.
2. Press Next repeatedly to cycle through the screens displaying the current settings for
the serial port, MAC address, DHCP mode, IP address, gateway address, and subnet
mask.
3. Press Menu to return to the Comm./IP Configuration screen.
Making changes to the serial port and IP configuration
To make changes to the serial port configuration, IP address, DHCP mode, gateway
address, and subnet mask, access the edit level screens as follows:
1. With any Comm./IP Configuration menu view-level screen displayed, press the Enter
button and hold it until the Serial Config screen appears (approximately 2 seconds).
2. Press Next repeatedly to cycle through the edit level screens.
3. To enter or change information on each screen, rotate the horizontal Adjust knob ([)
to move the angle brackets to the desired setting. Rotate the vertical Adjust knob ({) to
adjust the setting.