Extron Electronics MGP Pro Series User Guide - Manual (Page 28)

MGP Pro Series • Operation 22
Output Configuration Menu
The Output Configuration menu allows you to set output resolution, refresh rate, output
signal type, and sync polarity. The following flow diagram shows the Output Configuration
submenus and the adjustments that can be made from them.
Figure 17. Output Configuration Menu Flow
Resolution and Refresh Rate submenu
While this submenu is displayed, rotate the horizontal Adjust ([) knob to select one of
the available resolutions, or rotate the vertical Adjust ({) knob to select one of the available
refresh rates. The resolutions and refresh rates are listed in the
table on the next page.
NOTE: The sync type and polarity options are available for the RGB output while the
background timings are used. If available, the output of the MGP Pro is locked to the
HDMI background rate until you select a different resolution or disconnect the HDMI
background input.
By default, the resolution provided in the Extended Display Identification Data (EDID) is the
last selected factory rate. To manually set the resolution information provided in the EDID
data, see the
EDID Resolution and Refresh Rate commands on page 51.