Burkert Type 8611 - Manual (Page 19)

19
Assembly
7.3.2. installation in a control cabinet
• Prepare control panel cut-out with the dimensions 45mm x 45mm (corner radius 3mm).
• Place the supplied seal on the housing.
• Insert the controller from the front into the control panel cut-out.
• From the rear, snap the 4 supplied fastening elements into place and fasten using a screwdriver.
4 Fastening elements
Seal
Figure 7: Installation elements Figure 8: Installed controller
recommended line cross sections for the control cabinet model:
cross section
min. cross section
max.
Minimum length
Cross section for flexible lines 0.2 mm² 1.5 mm² 10 mm (stripping)
Cross section for flexible lines with cable end
sleeve without plastic sleeve
0.25 mm²
1.5 mm² 10 mm
Cross section for flexible lines with cable end
sleeve with plastic sleeve
0.25 mm²
0.75 mm² 10 mm
Table 3: Recommended line cross sections
english
Type 8611