Burkert Type 8695 - Manual (Page 20)

20
Installation
→
Push the control head, without turning it, onto the actuator until no gap is visible on the form seal.
noTe!
too high torque when screwing in the fastening screw does not ensure degree of protection ip65 /
ip67.
▶ The fastening screws may be tightened to a maximum torque of 0.5 Nm only.
→
Attach the control head to the actuator using the two side fastening screws. In doing so, tighten the screws
only hand-tight (maximum torque: 0.5 Nm).
Connection
pieces
Pilot air ports
(actuator)
Fastening screws
max. 0.5 Nm
Figure 8: Installation of control head
english
Type 8695