Burkert Type 8695 - Manual (Page 36)

36
Electricalinstallation24VDC
→
Using the jumpers, assign the required color to the end position LEDs.
ye gn
Bo
t
To
p
To
p
Bo
t
ye gn
Jumper for
assignment of end
position LEDs
End position LED green
End position LED yellow
ye
gn
Bot
Top
Top
Bot
ye
gn
ye
gn
Bot
Top
Top
Bot
ye
gn
Jumper setting 1:
In the end position top (Top),
the yellow LED is lit; in the
end position bottom (Bot),
the green LED is lit.
Jumper setting 2:
In the end position top (Top),
the green LED is lit; in the
end position bottom (Bot),
the yellow LED is lit.
Figure 24: Description end position LEDs and Jumper - 24 V DC
noTe!
Breakage of the pneumatic connection pieces due to rotational impact.
▶ When unscrewing and screwing in the transparent cap, do not hold the actuator of the process valve but the
connection housing.
Damage or malfunction due to penetration of dirt and humidity.
▶ To observe degree of protection IP65 / IP67, screw the transparent cap in all the way.
→
Close the device (assembly tool: 674078 4) ).
Body casing
Connection housing
Actuator
Transparent cap
Figure 25: Close control head
4)
The assembly tool (674078) is available from your Bürkert sales office.
english
Type 8695