Burkert Type 8695 - Manual (Page 39)

39
AS-Interfaceinstallation
10.4.3 connection with multi-pole cable and ribbon cable terminal
As an alternative to the bus connection model with 4-pole circular plug, there is the control head with multi-pole cable
(M12 circular plug) and ribbon cable terminal. The wiring diagram of the circular plug corresponds to the bus con-
nection of the M12 4-pole circular plug and can easily be connected to the ribbon cable terminal (see “Figure 28”).
Figure 27: Control head 8695 with multi-pole cable and ribbon cable terminal
handling the ribbon cable terminal
The multi-pole cable features a ribbon cable terminal - with M12 plug-in connector branch circuit - for AS-Interface
cable harness. The ribbon cable terminal contacts the AS-Interface cable harness by means of penetration technology
which allows installation by “clipping in” the AS-Interface cable harness without cutting and without removing insulation.
Screws
M12 plug-in con-
nector branch circuit
Work steps:
→
Open the ribbon cable terminal
(loosen screws and remove cover)
→
Insert cable harness conclusively
→
Close ribbon cable terminal again
→
Tighten screws
Slightly undo thread-forming screws
(approx. 3/4 turn to the left) and position them on the
existing tapped bore and screw in.
Figure 28: Ribbon cable terminal
english
Type 8695