Burkert Type 8695 User Manual
Page 23
Advertising
23
Installation
Fastening screws
maximum 0.5 Nm
Figure 12:
Installing the control head, series 20xx
noTe!
too high torque when screwing in the fastening screw does not ensure degree of protection ip65 /
ip67.
▶ The fastening screws may be tightened to a maximum torque of 0.5 Nm only.
→
Attach the control head to the actuator using the two side fastening screws. In doing so, tighten the fastening
screws hand-tight only (maximum torque: 0.5 Nm).
english
Type 8695
Advertising