Burkert Type 8695 - Manual (Page 44)

44
AS-Interfaceinstallation
10.6.4 end position leDs
The end position is displayed optically by colored LEDs.
ye gn
Bot To
p
To
p
Bot
gn ye
Jumper
for assignment of end position LEDs
End position LED green
End position LED yellow
Figure 33: Description end position LEDs and Jumpers - AS-Interface
noTe!
Breakage of the pneumatic connection pieces due to rotational impact.
▶ When unscrewing and screwing in the transparent cap, do not hold the actuator of the process valve but the
connection housing.
Body casing
Connection housing
Actuator
Transparent cap
Figure 34: Open control head
noTe!
Damage or malfunction due to penetration of dirt and humidity.
▶ To observe degree of protection IP65 / IP67, screw the transparent cap in all the way.
Factory setting:
color Device status
green LED on End position bottom
yellow LED off End position top
Table 11: Assignment of LEDs - AS-Interface
10.6.5 Jumper function
You can set the color assignment of the end positions with the jumpers.
You can indicate for each color whether it applies to the Top (end position top) or Bot (end position bottom).
english
Type 8695