Burkert Type 8695 - Manual (Page 21)

21
Installation
7.3 installation of the control head Type 8695 on
process valves of series 20xx (classic)
Procedure:
1. install switch spindle
Transparent cap
Position indicator
Actuator
Figure 9: Installation of the switch spindle (1), series 20xx
→
Unscrew the transparent cap on the actuator.
→
Using a hexagon socket key, unscrew the orange/yellow position indicator from the inside of the actuator.
Guide element
O-ring
Plastic part
(of the switch spindle)
Puck
Switch spindle
Spindle (actuator)
Figure 10: Installation of the switch spindle (2), series 20xx
→
Press the O-ring downwards into the cover of the actuator.
→
Manually screw the switch spindle (and the plugged-on guide element) together with the plastic part onto the
spindle of the actuator, but do not tighten spindle yet.
→
Tighten the guide element with a face wrench 1) into the actuator cover (maximum torque: 8.0 Nm).
→
Tighten the switch spindle on the spindle of the actuator. To do this, there is a slot on the upper side
(maximum torque: 1.0 Nm).
→
Push the puck onto the switch spindle until it engages.
1)
journal Ø: 3 mm; journal gap: 23.5 mm
english
Type 8695