Burkert Type 8750 - Manual (Page 25)

25
Start-up 24 V DC
Typ 8750
11. sTarT-up 24 V dc
Warning!
risk of injury from improper operation.
Improper operation may result in injuries as well as damage to the
device and the area around it.
▶ Before start-up, ensure that the operating personnel are familiar
with and completely understand the contents of the operating
instructions.
▶ Observe the safety instructions and intended use.
▶ Only adequately trained personnel may operate the system/the
device.
A detailed description of the start-up and operating procedures
for Type 8693 can be found in the operating instructions for
Type 8693.
To set up the flow controller, perform the following steps:
• Specify the standard settings of the process controller (input signal
(standard signal)).
• Perform the automatic adjustment ( X.TUNE) of the process controller.
• Add the F.CONTROL auxiliary function to the main menu using the
configuration menu ( ADDFUNCTION) and create settings.
11.1. General procedure for creating
settings for the flow controller
Key Action Description
MENU MENU Press for 3 s
(countdown in the
display)
Switching from
process level
setting level
→
Execute settings.
MENU EXIT Press
Switching from
setting level
process level
Tab. 16: General procedure for creating settings
You must exit the main menu by pressing the left selection
key
MENU EXIT before the modified data is saved to the
memory (EEPROM). During the save process, the save symbol
is indicated on the display.
english