Burkert Type 8750 - Manual (Page 31)

31
Additional FMR functions
Typ 8750
no description
1 Selecting the transfer characteristic between input signal and
stroke (correction characteristic)
2 Sealing function for position controller
3 Effective sense of direction between input signal and nominal
position
4 Assignment of the aeration state of the actuator chamber to
the set-point position
5 Signal split range 14) ; input signal as a % for which the valve
runs through the entire stroke range.
6 Limit the mechanical stroke range
7 Limit the control speed
8 Parameterization of the position controller
9 Parameterization of the PID process controller
10 Code protection for settings
11 Input the safety position
12 Configuration of signal level fault detection
13 Activation of the binary input
14 Configuration of outputs (option)
15 Calibration
16 Reset to factory settings
17 Configuration of serial interface
18 Adjusting the display
no description
19 For internal use only
20 Simulation of set-point value, process valve, process
21 Diagnosis menu (option)
Tab. 21: Description of auxiliary functions
14)
The auxiliary function SPLTRNG can only be selected if
F.CONTROL (process control) is not activated.
The auxiliary functions listed here can be activated and set in accor-
dance with the control task.
A detailed description of the auxiliary functions and settings
can be found in the user instructions for Type 8693.
The following auxiliary functions differ from Type 8693 and are
described in these instructions:
•
CAL.USER see Chapter “12.2. CAL.USER - Changing the
factory calibration”
• OUTPUT see Chapter “12.3. OUTPUT - Configuration of
the analog output”
english