Clear-Com VOICE2 - Manual (Page 22)

Vitec Group Communications
VoICE IP Interface User Manual
2 - 2
2. 3 x Straight Ethernet patch cords (UTP Cat5 or better) – the kind of
cable you would connect a computer to a hub with (NOT a crossover
cable that you would use to connect a computer to a computer or a
hub to a hub with).
Figure 2-2: CAT5 Cable
One for each of:
• Client
• Server (this will look he same as the Client)
• PC
3. An Ethernet Hub (or Switch).
This may be part of your corporate network later, but during initial
setup it may be easier to work isolated.
What you need from your Network Administrator:
1. An IP Address per
The units require a fixed IP address. Please contact your network
administrator in order to obtain an IP address for your unit(s).
2. Subnet masks for each
3. Default Gateway settings for each
4. DNS server entries for each unit (optional – if, later in the
configuration, you would prefer to use a name instead of IP address
to refer to the server from the client then a DNS entry is required).
Record the Network Settings that you have been given here:
Server IP Address:
y y y
A A1 A2 A3 A4
Subnet Mask:
y y y
B B1 B2 B3 B4
Default Gateway:
y y y
C C1 C2 C3 C4