Clear-Com VOICE2 - Manual (Page 25)

Vitec Group Communications
VoICE IP Interface User Manual 2 - 5
CONFIGURE THE PC READY FOR INITIAL SETUP
This enables the PC to talk to the units so that the web browser can be
used to set configuration items.
Background
A unit and its associated configuration PC must reside on the same IP
subnet.
The units LAN 1 port is adjustable to match your network.
The units LAN 2 port has a fixed IP address of 10.0.0.1.
Temporarily configuring your PC to operate on the 10.0.0.XX subnet
will allow you to configure the unit via the LAN 2 port.
( Once this is complete, the first configuration change will be to modify
the units LAN 1 IP address to match your network).
Changing the IP address of the PC
You will require administrator access to the pc in order to change the
IP Address to enable access to the units for the first time.
Note: After correctly configuring the units for your network the IP
Address of the PC can be returned to it’s original state.
If in doubt contact your network administrator.
Changing the IP Address of the PC in Windows
2000
1. Disconnect your PC from any Ethernet network it may be connected
to.
2. From the Start menu choose Settings and then click on Network
Connections.
Figure 2-3: Start Menu