Clear-Com VOICE2 - Manual (Page 81)

Vitec Group Communications
VoICE IP Interface User Manual 5 - 7
Figure 5-9: Installation Completion Screen
Click on the Launch checkbox to cancel launching SOFT-VoICE if it is
not required to be started when the installer exists. The default is to
start SOFT-VoICE when the installer exits.
Click on the ‘Finish’ button to complete installation.
When run for the first time, SOFT-VoICE will ask for a Playback
device (audio from matrix) and a Recording device (audio to matrix).
Before establishing a connection to your VoICE server you will need to:
• Enter information into the General Configuration dialogue by
choosing General/Network from the Options menu. In the
Connection section enter your VoICE server’s IP address in the
Server box and choose your allocated VoICE channel from the
Port drop-down list.
• Ensure that the Sampling Rate in the Audio Configuration dialogue
is set to match the Sampling Rate in the VoICE server and choose
your desired codec and bit rate by choosing Codecs from the
Options menu.
• Connect the allocated VoICE channel to a suitably configured Eclipse
MVX port.
To connect SOFT-VoICE choose Connect from the File menu.